A Flipper Zero application to control CaiXianlin shock collar.
WARNING: This application is intended for educational and research purposes only.
NOTE: I don't endorse use of these devices on any animals. You do you, but I'd never use this device on an animal.
- Send shock, vibrate, or beep commands
- Adjustable strength (0–100)
- Channels (0–2)
- Clone/Listen mode – Capture Station ID and channel from an existing remote controller / hub
- Persistent settings – Station ID and channel are saved
Main Screen:
| Button | Action |
|---|---|
| OK (hold) | Transmit signal |
| ← / → | Change mode (Shock/Vibrate/Beep) |
| ↑ / ↓ | Adjust strength (0–100) |
| Back (short) | Exit app |
| Back (hold) | Open setup screen |
Setup Screen:
| Button | Action |
|---|---|
| ↑ / ↓ | Navigate menu |
| ← / → | Change channel (when selected) |
| OK | Select option |
| Back | Return to main screen |
RF Parameters:
| Parameter | Value |
|---|---|
| Frequency | 433.92 MHz |
| Modulation | ASK/OOK |
| Preset | FuriHalSubGhzPresetOok270Async |
Bit Encoding:
| Element | HIGH Duration | LOW Duration | Ratio |
|---|---|---|---|
| Sync | ~1250 µs (5 TE) | ~750 µs (3 TE) | 5:3 |
| Bit 1 | ~750 µs (3 TE) | ~250 µs (1 TE) | 3:1 |
| Bit 0 | ~250 µs (1 TE) | ~750 µs (3 TE) | 1:3 |
Where TE (Time Element) ≈ 250 µs
Based on https://wiki.openshock.org/hardware/shockers/caixianlin and captured signals from the controller hub. The app is using integer ratios matching the behavior of a real controller, rather than strictly following the protocol as specified in the wiki.
Packet Structure (42 bits):
[SYNC] [STATION_ID:16] [CHANNEL:4] [MODE:4] [STRENGTH:8] [CHECKSUM:8] [END:2]
| Field | Bits | Range | Description |
|---|---|---|---|
| Station ID | 16 | 0-65535 | Transmitter identifier (collar paired to this) |
| Channel | 4 | 0-2 | Channel number |
| Mode | 4 | 1-3 | 1=Shock, 2=Vibrate, 3=Beep |
| Strength | 8 | 0-100 | Intensity (should be 0 for Beep) |
| Checksum | 8 | 0-255 | 8-bit sum of all preceding bytes |
| End | 2 | 00 | Always 00 |
Checksum Calculation:
checksum = (STATION_ID_high_byte + STATION_ID_low_byte + Channel + Mode + Strength) & 0xFFOn the first launch, the setup screen will appear. You can:
- Manually enter the Station ID (if you know it)
- Set the channel (0-2)
- Use Listen for Remote to clone an existing remote
- Press Done to start using the app
Settings are automatically saved and will be restored on the next launch.
MIT License – see LICENSE file for details.
- Protocol analysis based on https://wiki.openshock.org/hardware/shockers/caixianlin and reverse engineering of captured signals from the controller hub
- Flipper Zero firmware team for the excellent SDK